Zanussi ZRB33100XA Benutzerhandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gefrierschrank Zanussi ZRB33100XA herunter. Zanussi ZRB33100XA 45 Seiten.
Auch für Zanussi ZRB33100XA: Benutzerhandbuch (29 seiten)

Seite drucken

Problem

Water flows on the floor.

The temperature in the appli-

ance is too low/too high.

Side panels of the appliance

are warm.

There is too much condensed

water on the rear wall of the

refrigerator.

There is frost on the rear wall

of the refrigerator.

Door does not open easily.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

REPLACING THE LAMP

The appliance is equipped with a long-

life LED interior light.

Possible cause

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

The temperature regulator is

not set correctly.

The food products tempera-

ture is too high.

Many food products were

stored at the same time.

This is a normal state caused

by operation of the heat ex-

changer.

Door was opened too fre-

quently.

Door was not closed com-

pletely.

Stored food was not wrap-

ped.

The ambient temperature is

high and the appliance is set

to the lowest temperature.

The appliance is fully loaded

and is set to the lowest tem-

perature.

You attempted to re-open the

door immediately after clos-

ing.

Solution

Attach the melting water outlet to

the evaporative tray.

Set a higher/lower temperature.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Store less food products at the

same time.

Make sure that there is at least

30 mm of space between each

side of the appliance and the

surrounding furniture when the

ambient temperature exceeds

38°C.

Open the door only when neces-

sary.

Make sure the door is closed

completely.

Wrap food in suitable packaging

before storing it in the appliance.

Set the temperature regulator to

a higher temperature to allow au-

tomatic defrosting.

Set the temperature regulator to

a higher temperature to allow au-

tomatic defrosting.

Wait a few seconds between

closing and re-opening of the

door.

It is strongly recommended to use

original spare parts only.

Use LED bulbs (E14 base) only. The

maximum power is shown on the lamp

unit.

CAUTION! Disconnect the plug from

the mains socket.