Zanussi ZVC 2000 S Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Gefrierschrank Zanussi ZVC 2000 S herunter. Zanussi ZVC 2000 S 9 Seiten.

Door reversibility

Unplug the freezer before performing the following

operations:

Remove the ventilation grill (D).

Remove the lower hinge (E) by loosening the two

fastening screws.

D640

Remove the door by sliding it out of the upper pin

(A-Fig. 3).

Unscrew the pin and the washer (A+B-Fig. 3) and

reﬁt them on the opposite side.

D427

Reﬁt the door.

Reﬁt the lower hinge (E-Fig. 2) on the opposite side

by means of the two screws that have been

previously removed.

Remove the plug (F) from the ventilation grill (D)

and replace it on the opposite side.

Reﬁt the ventilation grill.

Fig. 2

Fig. 3

Remove the handle and reﬁt it on the opposite side

(Fig. 4).

D162

The holes that are not used are to be masked with

the plastic plugs removed.

If, after having reversed the door, it is not in line

with the unit, the top hinge can be adjusted.

To do this, use a 10 mm spanner as shown in

Figure 3; slacken the nut, align the door by pushing

it to the left or right, then re-tighten the nut.

Attention

After having reversed the opening direction of the door

check that all the screws are properly tightened and that

the magnetic seal adheres to the cabinet. If the ambient

temperature is cold (i.e. in Winter), the gasket may

not ﬁt perfectly to the cabinet. In that case, wait for

the natural ﬁtting of the gasket or accelerate this

process by heating up the part involved with a

normal hairdrier.

Fig. 4