Zanussi ZVR11R Gebrauchsanweisung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Gefrierschrank Zanussi ZVR11R herunter. Zanussi ZVR11R 20 Seiten. Zanussi instruction freezer zvr11r

Seite drucken

Electrical connection

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent person.

This appliance must be earthed.

The manufacturer declines any liability should

these safety measures not be observed.

Electrical Requirements

Before switching on, make sure the electricity

supply voltage is the same as that indicated on the

appliance rating plate.

The appliance is supplied with a 13amp plug fitted.

In the event of having to change the fuse in the plug

supplied, a 13amp ASTA approved (BS1362) fuse

must be used.

Should the plug need to be replaced for any reason.

The wires in the mains lead are coloured in

accoordance with the following code:

Green and yellow

-Earth

Blue

-Neutral

Brown

-Live

Door Reversal

1. Close the cabinet and pull out the plug from the

electrical outlet.

2. Remove the ventilation grille. There is a part on

the grille that can be removed. Remove it and

transfer to the opposite side.

3. Support the cabinet on a wooden block when it is

laid down. It will be easier to grip under the cabinet

when resupporting to an upright positon.

4. On the upper part of the cabinet. Put the hinge pin

on the other side.

5. On the lower part of the cabinet. Unscrew the

hinge. Move the hinge pin and plastic cover. Secure

the hinge on the other side.

6. Raise the cabinet and replace the ventilation grille.

7. Unscrew the handle. Carefully press in the plastic

plugs on the opposite side using a punch. Secure the

handle in the plug holes. Then press the supplied

plastic plugs into the holes to which the handle was

previously fitted.

8. Put the cabinet in position. Check that it stands

straight. See the section "Positioning the cabinet".

The wire coloured green and yellow must be

connected to the terminal marked with the letter "E"

or by the earth symbol

yellow.

The wire coloured blue must be connected to the

terminal marked "N" or coloured black

The wire coloured brown must be connected to the

terminal marked "L" or coloured red.

Upon completion there must be no cut, or stray

strands of wire present and the cord clamp must be

secure over the outer sheath.

or coloured greeen and

Zanussi 818 15 02--02/5