Directed Directechs DB3 Installationshandbuch - Seite 5

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the Vehicle connections section following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

[2] Tach wire: Optional connection required on some remote starters, which do not support a tach signal in D2D

[3] EMS COM: This connection is not required in US vehicles without transponder.

[4] Immobilizer Interrupt: Vehicles with a transponder will require the immobilizer Orange/Black and Yellow/Black connections.

However, for some vehicles, the immobilizer interrupt may not be required. If this is the case, the vehicle will crank but not remote

start. Therefore, you must permanently reconnect the interrupt, leaving the Orange/Black and Yellow/Black connections, and retry

the remote starter.

403.HK3 3.04 2016 Hyundai Santa Fe Sport

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation