Directed Directechs DB3 Installationshandbuch - Seite 4

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Manual transmission: Vehicles with manual transmission must configure the clutch bypass with a starter output instead of a GWR

(Status) output to avoid remote start failure.

Immo. bypass: This firmware does not support Immobilizer bypass. One (1) programmed OEM key must be wired into the vehicle to

complete the installation of a remote starter.

Diesel delay: This firmware may require a 2-second minimum Diesel Delay for certain analog modules to avoid remote start failure.

Refer to the remote starter install guide for proper configuration.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory

hood pin, or if not supported in data

[2] Tach:

The tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] Immo. bypass: Refer to the "Immobilizer Interface" section for more information about key wrap.

403.VW18 2.05 2024 Volkswagen Jetta GLI (Smart Key)

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation