Zanussi ZHT850X Gebrauchsanweisung - Seite 23
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Lüftungshaube Zanussi ZHT850X herunter. Zanussi ZHT850X 32 Seiten.
Seite drucken
B. Installation
1. Location:
(FIG. 1)
• Air turbulence is from window/door may reduce
the effectiveness of hood.To suggest close
window/door before use hood.
• The smoke has to rise up to 25 cm to be within
the range of suction efficiency.
2.
Position:(FIG. 2)
• The installation height is measured vertically
from center of fan grille of hood to the top of
the stove.
• The minimum installation height should not
be less than 650mm and the recommended
height is 700±50 mm.
• Avoid left-right or front-dropped inclination.
3. Exhaust
duct:(FIG. 3)
• 6-inch diameter exhaust duct is recommended
to use in order to maximize suction efficiency.
In case of 5-inch exhaust duct, an adapter as
enclosed in the packaging can be used.
• Before installing the hood,please apply fast
drying glue to the collar and securely attach
it to the top of the cooker hood's vent lid.
Install the cooker hood and exhaust duct to
the plastic collar and seal with fast drying
glue.
C. Mounting Method
1. Rear mounting
• Use 2 wooden screws and 2 washers to secure
the hood to the wall. (See FIG. 4)
2. Top mounting(Only for ZHT850X and ZHT900X)
• Use 4 wooden screws and 4 washers to secure
the hood to the bottom of the cabinet. Lift
hood onto screws located on cabinet bottom
and lock into place. Make sure all 4 key-holes
cover the screws. Tighten each screw to secure
hood to cabinet. (See FIG. 5)
Stick the two round rubber stands on the sides
of hood's top (See FIG. 6).
(Note: Make sure all 4 key-holes cover the
screws and each screw was tightened.
Otherwise, there will be potential risk of
machine fall down.)
Installation Guidelines
6
(FIG. 1)
(FIG. 2)
Exhaust
duct
(FIG. 3)
696mm
(FIG. 4)
(FIG. 5)
(FIG. 6)