Zanussi GAS COOKER ZCG 641 Gebrauchsanweisung - Seite 17

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Herde Zanussi GAS COOKER ZCG 641 herunter. Zanussi GAS COOKER ZCG 641 20 Seiten. Zanussi cooktop user manual

Seite drucken

Electrical connections

Any electrical work required to install this cooker

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability should these safety

measures not be observed.

This cooker is designed to be connected to a 230V 50Hz

AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the cooker

rating plate. The rating plate is located on the oven

frame.

The cooker is supplied with a 3 core flexible supply

cord incorporating a 13amp plug fitted. In the event of

having to change the fuse, a 13amp ASTA approved

(BS 1362) fuse must be used.

Should the plug need to be replaced for any reason,

the wires in the mains lead are coloured in accordance

with the following code:

Green and Yellow - Earth

Blue

- Neutral

Brown

- Live

— Connect the green and yellow (earth) wire to

the terminal in the plug which is marked with

the letter 'E' or the earth symbol

coloured green and yellow. The earth wire

should be about 2 cm longer than the neutral

and live wires.

— Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N'

or coloured black.

— Connect the brown (live) wire to the terminal

in the plug which is marked with the letter 'L'

or coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure

over the outer sheath.

A cut off plug inserted into a 13 amp socket

is a serious safety (shock) hazard. Ensure that

the cut off plug is disposed of safely.

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the cooker

and the electricity supply (mains), with a minimum gap

of 3 mm. between the switch contacts and of a type

suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth

wire at any point. The earth wire should be about 2 cm

longer than the neutral and live wires.

Ensure that the cooker supply cable does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

FO 0390