Zanussi ZCE 610 X Gebrauchsanweisung - Seite 25

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Herde Zanussi ZCE 610 X herunter. Zanussi ZCE 610 X 25 Seiten. Electric cooker
Auch für Zanussi ZCE 610 X: Gebrauchsanweisung (28 seiten), Gebrauchsanweisung (28 seiten)

Seite drucken

Electrical connections

Any electrical work required to install this

hob should be carried out by a qualified

electrician or competent person, in

accordance with the current regulations.

THIS COOKER MUST BE

EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

This cooker is designed to be connected to

a 230-240V 50Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this

book.

The cooker is supplied without supply cord. A 3 core

flexible supply cord must be fitted, in accordance

with the specification given in the relevant tables.

1) Loosen the two fixing screws securing the

back protective screen of the cooker, then lift

it up and remove it. This will expose the

terminal block on the right bottom corner.

2) Loosen the two cable clamp screws and lift

the top section of the clamp enough to allow

the cable to be passed through.

3) Connect the red (live) wire to the terminal

which is marked with the letter "L".

4) Connect the black (neutral) wire to the

terminal which is marked with the letter "N".

5) After fitting a green or yellow/green sleeve

over the bare copper wire (earth wire), connect

the exposed end to the terminal which is

marked with the earth symbol

letter "E"coloured green and yellow.

NOTE:

The earth wire should be about 2 cm. longer

than the live and neutral wires.

6) Secure the cable by means of the clamp screws

and refit the back protective screen.

The cooker should be connected to a double pole

switch with a minimum gap of 3 mm. between the

switch contacts and of a type suitable for the required

load in compliance with the current electric

regulations. The switch should be sited within 2m of

the hob and be easily accessible upon completion of

the installation.

The switch must not break the yellow and green earth

cable at any point.

Supply Cable Specifications

For Uk use only

Connection

via

• Cooker

Control

Circuit

For Europe use only

Min. size Cable/flex

3x 2.5 mm

or with the

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

Min. size

Cable / flex Fuse

Cable/flex

type

3 x 6 mm

H05 VV-F

Cable / flex type

H05 RR-F

FO 2375

30 A

Fuse

30 A