Zanussi ZCE641 Gebrauchsanweisung - Seite 19

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Herde Zanussi ZCE641 herunter. Zanussi ZCE641 20 Seiten. Range cookers
Auch für Zanussi ZCE641: Merkmale und Funktionen (9 seiten)

Seite drucken

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician

or competent person, in accordance with the

current regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This cooker is designed to be connected to a 230V

50Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the cooker

rating plate. The rating plate is located on the oven

frame.

The cooker is supplied without supply cord. A 3 core

flexible supply cord must be fitted, in accordance with

the specification given in the relevant tables.

1) Loosen the two fixing screws securing the back

protective screen of the cooker, then lift it up

and remove it. This will expose the terminal

block on the right bottom corner.

2) Loosen the two cable clamp screws and lift

the top section of the clamp enough to allow

the cable to be passed through.

3) Connect the red (live) wire to the terminal which

is marked with the letter "L".

4) Connect the black (neutral) wire to the terminal

which is marked with the letter "N".

5) After fitting a green or yellow/green sleeve over

the bare copper wire (earth wire), connect the

exposed end to the terminal which is marked

with the earth symbol

"E"coloured green and yellow.

NOTE:

The earth wire should be about 2 cm longer

than the live and neutral wires.

6) Secure the cable by means of the clamp

screws and refit the back protective screen.

or with the letter

The cooker should be connected to a double pole switch

with a minimum gap of 3 mm. between the switch

contacts and of a type suitable for the required load in

compliance with the current electric regulations. The

switch should be sited within 2m from the cooker and

easily accessible upon completion of the installation.

The switch must not break the yellow and green earth

cable at any point. The earth wire should be about 2

cm longer than the live and neutral wires.

Ensure that the hob supply cable does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

Supply Cable Specifications

For Uk use only

Connection

Min. size

via

Cable/flex

• Cooker

6 mm

Control

Circuit

For Europe use only

Min. size Cable/flex

3x 2.5 mm

FO 2375

Cable / flex Fuse

type

H05 VV-F

30 A

Cable / flex type

Fuse

H05 RR-F

30 A