Zanussi ZCV68310XA Benutzerhandbuch - Seite 20

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herde Zanussi ZCV68310XA herunter. Zanussi ZCV68310XA 28 Seiten.
Auch für Zanussi ZCV68310XA: Benutzerhandbuch (28 seiten)

Seite drucken

1. Installation

Levelling

Use small feet on the bottom of appliance to

set same level of cooker top surface with other

surfaces

The anti-tilt protection

Caution! You must install the anti-tilt

protection (A+B). If you do not install it

the appliance can tilt.

Before you install anti-tilt protection, adjust the

appliance to the correct height.

The anti-tilt protection has two parts (A+B).

You can find the anti-tilt protection (B) on right

or left side of the rear wall of the appliance

(See fig. 1). You must install the anti-tilt pro-

tection (A) on the wall. The distance of the

hole of the anti-tilt protection (A) from the floor

is about 816 mm. Make sure you install the an-

ti-tilt protection (A) at the correct height.

Screw it into the solid material or use applica-

ble reinforcement.

Check that the anti-tilt protection projects min-

imum 20 mm into the hole in the back of the

appliance (B) when you push the appliance

(See fig. 2). If the space between the bench

cupboards is greater than the width of the ap-

pliance, you must adjust the side measurement

to centre the appliance. Make sure that the

surface behind the appliance is smooth.

Electrical installation

Warning! Only a qualified and

competent person must do the electrical

installation.

The manufacturer is not responsible if you

do not follow safety precautions from the

chapter "Safety information".

This appliance is supplied without a main plug

or a main cable.

Covering terminal board

The recommended cross-section area is six

square millimetres (6 mm²).

When you refit the mains terminal cover, make

sure that the lower tabs are located inside the

bottom edge of the aperture, before you fix the

two screws into the top edge of the mains ter-

minal cover.

Make sure that the cover is securely fastened.

To open the cover of terminal board obey

the procedure in opposite sequence.

60 mm

50 mm