Zanussi ZKC6020 Benutzerhandbuch - Seite 33

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herde Zanussi ZKC6020 herunter. Zanussi ZKC6020 40 Seiten. Zanussi cooker user manual
Auch für Zanussi ZKC6020: Merkmale und Funktionen (9 seiten), Benutzerhandbuch (40 seiten)

Seite drucken

Installation instructions

WARNING!

This appliance must be earthed

• If your appliance has been damaged in

transit, contact your supplier immediately.

Do not attempt to install it.

• Your appliance left the factory fully packaged

to protect it from damage. If it is delivered

without packaging and damage has

occurred, the manufacturer cannot accept

responsibility. Contact your supplier for

advice.

• Once the packaging has been removed the

appliance should only be moved by hand.

Do not use a sack barrow or any other aid to

lift the appliance as damage may occur.

• To move the appliance, open the oven door

and lift the appliance by holding inside the

top of the compartment.

• This is a type Y appliance, which means it is

freestanding and can be fitted with cabinets

on one or both sides. It may also be fitted in

a corner setting.

• Sidewalls, which are above hob level, should

be protected by heat resistant non-

combustible material and must not be nearer

than 40mm to the hob side.

• A nominal air gap of 2mm at either side of

the appliance is required to enable the

appliance to be moved into position.

• Always ensure an air gap is maintained at

hotplate level. Tiles or other forms of deep

wall covering should not obscure this gap.

• Overhanging surfaces or a cooker hood

should be a minimum of 685mm above the

hob.

min

• It is important to ensure that the appliance is

level after installation. Levelling feet are fitted

to the appliance to accommodate uneven

floors.

Connecting to the electricity

supply

WARNING!

This appliance must be earthed. Do not earth

this appliance to gas supply piping. Connect

to 230 - 240V AC supply only.

• Connection to the electricity supply must be

carried out by a qualified

electrician/competent person.

• The electrical connection should be made

using a double pole isolating switch (cooker

socket) with at least 3mm contact separation

in all poles. The cable must have

conductors of sufficiently high cross-

sectional area to prevent overheating and

deterioration.

685 min