Zanussi ZKG6020 Benutzerhandbuch - Seite 34

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herde Zanussi ZKG6020 herunter. Zanussi ZKG6020 40 Seiten. Zanussi cooker user manual
Auch für Zanussi ZKG6020: Merkmale und Funktionen (9 seiten)

Seite drucken

•

Curtains must not be fitted immediately

behind the appliance or within 150mm of the

sides of the hob. If fitted next to or between

two base units a minimum space of 2mm

must be left between each unit and the sides

of the appliance. The levelling feet fitted to

the appliance will achieve a nominal height

to hob of 900mm + 20mm.

Leveling the appliance

• Adjustment to suit floor conditions or height

is obtained by rotating clockwise or anti

clockwise the feet at the front and rear of the

appliance. A spirit level should be placed on

one of the shelves to confirm the appliance

is correctly leveled.

Connecting to electricity supply

This appliance must be earthed.

Do not earth this appliance to the gas supply

piping.

Connect to 230-240 A.C supply only.

• Connection to the electricity supply should

be made via a properly earthed, readily

accessible wall socket. Which is adjacent to,

but not directly above and not more than

1.7m away from the appliance and capable

of electrical isolation. The cooker point

should be within 1.7m of the appliance to

make it accessible to switch off the appliance

in case of emergency. The mains lead

should be routed so that it cannot touch hot

parts of the cooker i.e. the back panel above

a height of 650mm from the floor.

• Should this plug not fit the socket outlet in

your home it should be cut off and replaced

with a suitable plug as outlined below.

• If the moulded plug is cut from the cable

for any reason it must be destroyed or

disposed of safely, as protruding wires

will be an electrical shock hazard.

If the fitted plug is removed.

• The flexible mains lead must be correctly

connected as below to three-pin plug of not

less than 13amp capacity. If a B.S. 1363

fused plug is used, it must be fitted with a 3-

amp fuse, which is approved to B.S. 1362.

The wires in the mains lead fitted to the

appliance are coloured in accordance with the

following code.

Green and yellow -Earth

Blue -Neutral

Brown -Live

• As the colours of the wires in the mains lead

of this appliance may not correspond with

the coloured markings identifying the

terminals in your plug, proceed as follows: -

• The wire, which is, coloured green and

yellow must be connected to the terminals in

the plug, which is marked with the letter E or

by the earth symbol ( ) or coloured green

or green and yellow.