Clarke XEV16/150 Handbuch für Betrieb und Wartung - Seite 13
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Luftkompressor Clarke XEV16/150 herunter. Clarke XEV16/150 17 Seiten. Electric motor driven
Auch für Clarke XEV16/150: Handbuch für Betrieb und Wartung (17 seiten), Handbuch für Betrieb und Wartung (17 seiten)
Seite drucken
SYMPTOM
Machine
running but not
pumping air
into the
receiver (10HP
only)
Compressor
becomes too
hot.
Oil in the air
delivered
Condensation
in crank case
(especially in 2-
stage
compressors).
Condensation
at outlet points
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PROBABLE CAUSE
Air exhausting from solenoid after
starter has changed direction
from star to delta.
Insufficient ventilation
Oil level too low (check 2 or 3
times after stopping).
Fault in valves (machine not
stopping).
Blown head gasket (machine not
stopping).
Dirt on cooling fins or suction filter.
Unit working at too high a
pressure
Non-return valve partly blocked.
Compressor being overworked
and running continuously.
Sump over full
Cylinder worn
Intake air filter blocked
Compressor over dimensioned
(operational periods to short in
relation to resting periods).
Piping installation is incorrect
Compressor is taking in air that is
too warm
Delivery temperature of air from
air receiver is too high
REMEDY
Check solenoid valve
Contact Clarke Service
See that sufficient air is
supplied to flywheel or fan of
compressor and that hot air is
properly vented.
Fill with oil - See page 7.
Contact Clarke Service
Contact Clarke Service
Clean cooling fins and suction
filter.
Contact Clarke Service
Clean or thaw out non-return
valve.
Use a larger compressor
Reduce oil to correct level
Contact Clarke Service
Change air filter
Frequent oil changes
Reduce Cooling of crank case
(e.g. by shielding it from the air
stream).
Contact Clarke Service
Consult your local dealer
Obtain better fresh air supply
for the compressor.
Use a larger air receiver
Contact Clarke Service
13