Blackberry RADAR H2 ITC100-1 Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationshandbuch für Radar Blackberry RADAR H2 ITC100-1 herunter. Blackberry RADAR H2 ITC100-1 30 Seiten. Magnet accessory
Auch für Blackberry RADAR H2 ITC100-1: Installationshandbuch (33 seiten), Installationshandbuch (28 seiten), Installationshandbuch (35 seiten), Installationshandbuch (25 seiten), Installationshandbuch (35 seiten)

6. Remove the template. You now have four holes in the door. If there are any burrs

around the holes, remove them at this time. Also, remove any dust or debris left over

from the drilling or de-burring operations.

7. Mount the module to the door using one of the approaches below. The recommended

procedure will differ slightly based on door placement.

Higher door placement

Having drilled a hole slightly smaller than your fastener, use a drill and nut

•

driver to drive the bolt through the door. This will allow the threads to hold the

device in place while you raise the door.

Enter the trailer and install the nut and washer to the rear of the bolt—using

•

the appropriate tools to complete the fastening operation. Do not tighten

fastener beyond 3lb-ft. (4Nm) to avoid over compressing the mounting gasket.

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 39