Clarke 3120193 Betriebs- und Wartungsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Sander Clarke 3120193 herunter. Clarke 3120193 17 Seiten. Multi-sander kit

FITTING THE GRINDING STONE

IMPORTANT: Never use chipped or cracked grindstones.

1. Slip the shank of the chosen stone

into the collet and tighten the

retaining collar finger tight.

2. Place the smaller of the two

wrenches over the collet seat to

stop the tool from rotating.

3. Use the larger wrench to fully

tighten the collet and grip the

stone in position as shown.

FITTING THE SANDING DISC

1. Fit the larger collet to the tool and

slip the spindle into the collet.

Secure in place by tightening the

collar as above.

2. Screw the sanding arbor onto the

spindle and secure by tightening

the nut against it using the larger

wrench.

3. Screw the sanding pad onto the

sanding arbor.

1. Use your thumb to slide the

throttle locking lever forward while

squeezing the trigger against the

body of the tool.

2. Adjust the tool speed by varying

the pressure on the trigger.

3. Do not use excess pressure on the

grinding stone as this will shorten

its life.

4. Release the trigger to stop the

tool.

• The tool will continue to rotate for a short time after the trigger has

been released.

5. Always ensure the tool has stopped before putting it down.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]