Clarke air CAT49 Betriebs- und Wartungsanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Sander Clarke air CAT49 herunter. Clarke air CAT49 13 Seiten. Long bed sander
Seite drucken
BEFORE USE
CONNECTING THE AIR SUPPLY
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
1. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done
regardless of whether or not a lubricated air supply is to be used.
2. Connect a suitable hose to the tool as shown using the airline connector
supplied with the tool.
3. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of the air tool. Remove the oil fill
screw from the side of the mini oiler and fill with air-line oil available
from your CLARKE dealer. Replace the screw before using the tool.
4. If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the inlet strainer or via the hose at
the nearest connection to the air supply.
5. Connect the other end of the hose to the compressor.
6. Turn on the air supply and check for air leaks. Rectify any found before
proceeding. PTFE tape may be useful for sealing threaded connections.
7. Your air tool is now ready for use.
You can fit a whip hose with a quick fit coupling if required (available from your
Clarke dealer.)
FITTING THE SANDING SHEET
• The CAT49 sander requires
70 x 400mm abrasive sheet
Fold the sheet around the
end of the bed and grip it
in position with the spring
clip at each end. Take care
that it is positioned
centrally.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6