Clarke air CAT54 Betriebs- und Wartungsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Sander Clarke air CAT54 herunter. Clarke air CAT54 17 Seiten.

BEFORE USE

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND COMPRESSED AIR SUPPLIES.

NOTE: Ensure the compressor is turned off.

1. If required, connect an in-line mini oiler to the tool.

• A mini oiler helps to prolong the life of the air tool.

2. If a mini-oiler is not being used, run

a few drops of oil through the tool

before use. It can be entered

through the air inlet or via the hose

at the nearest connection to the

air supply.

3. Connect a suitable hose to the air

inlet as shown.

4. Connect the other end of the hose

to the compressor.

Your air tool is now ready for use.

You can fit a whip hose with a quick fit coupling if required (available from

your Clarke dealer).

FITTING THE POLISHING DISC

Thread the polishing disc onto the

drive spindle, followed by the arbor

as shown.

Tighten the arbor using the wrench

with pins (C-spanner) provided while

using the other wrench to prevent

the drive shaft from rotating.

ATTACHING THE BONNET

1. Place the bonnet over the pad so the pad is completely covered.

2. Pull the draw string tight to ensure the bonnet will not slip.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]