Clarke CP180 Handbuch für Betrieb und Wartung - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Sander Clarke CP180 herunter. Clarke CP180 13 Seiten. Sander/polisher

When the handle is in place, secure it in position

with two allen screws and tighten the screws

using an 8mm Allen key. DO NOT overtighten.

Side Handle Only

To use the side handle only, screw into the D

shaped boss on either side of the body,

depending whether the tool is to be used left or

right handed. See Fig. 3. DO NOT overtighten.

Both Handles

To fit both handles, Fit the 'D' Handle as

described in section 1.

Only fit one Allen screw to the longest side of the handle as shown in Fig. 4, DO NOT

tighten yet.

Secure the other side using the side

handle, hand tight only, tighten the Allen

screw as before.

NOTE: store the spare Allen

screw for use to secure the 'D'

handle should it be necessary

to remove the side handle.

Fitting Backing Pads

To fit backing pads, depress the spindle

lock and screw the required backing

pad onto the spindle, hand tight only.

To remove the pads it may be necessary to use the spanner supplied.

IMPORTANT never depress the spindle lock whilst the motor is running. Failure to observe

this instruction may cause damage to the tool and could even lead to personal injury.

Depending on which pad is fitted, either the polishing bonnet or sanding discs can be

fitted.

When fitting the bonnet ensure the lace tails are tucked away before switching the

polisher on.

Allen Screw

-6-

Fig. 3

Fig. 4