Aleko BSW04 Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Spielgeräte & Spielplatzgeräte Aleko BSW04 herunter. Aleko BSW04 4 Seiten. Swing and glider set for children aged 3 to 10 years

Seite drucken

(See Fig. 7)

Step 6. Insert 1 G9 Plastic Spacer into either side of the holes near the center of the

Glider Legs.

Step 7. Attach the Glider Seat Tubes to either side of the Glider Legs using a G4 fastener

through the set of holes that the G9 Spacer has been installed in.

Step 8. Fasten Glider Seat to Glider Seat Tubes using 4 G6 Fasteners through both sets

of holes on both Seat Tubes. Repeat to assemble both Seats.

Step 9. Use G5 fasteners to secure Glider Footrest to lower holes in Glider Legs

Step 1. Attach Ground Pegs to all 4 Swing set Bottom Legs using P1 fasteners.

Step 2. Place assembled Swing Set in desired location and dig a footing hole,

measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each

support leg (Fig. 8).

Step 3. Prepare and pour concrete into the footing holes following concrete

manufacturer's instructions. Fully fill footing holes to be level with ground surface.

Step 4. While Concrete is still wet, Angle Ground Pegs toward swingset Top Bar at

roughly 120-degrees, then insert Ground Pegs into concrete footing, making sure

Swingset Bottom Legs do not sink below ground surface (utilize concrete set time

information). Use temporary support made from wood or other material if necessary to

prevent sinkage.

Step 5. Swing Set will be ready for use once concrete is fully set and cured (consult

concrete manufacturer's instructions).

Fig. 8