Clarke X-Pro CAT136 Betriebs- und Wartungsanleitung - Seite 10
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Sander Clarke X-Pro CAT136 herunter. Clarke X-Pro CAT136 17 Seiten. Dual action air sander
Seite drucken
4. If the tool runs erratically or becomes inefficient, and the air supply is of
good quality, it may be necessary to dismantle the air motor and replace
worn or damaged parts. You may prefer to take the tool to your Clarke
dealer if internal maintenance is required.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
**Clarke Air Line Oil (part no. 3050825) is available from your Clarke dealer.
Your Clarke air tool has been designed to give long and trouble free service. If,
however, having followed the instructions in this booklet carefully, you
encounter problems, take the unit to your local Clarke dealer.
STORAGE
When not in use, disconnect from air supply, clean & store in a safe, dry place.
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
ACCESSORIES
A wide range of accessories is available including filter/regulators, lubricators,
high-pressure hoses (5 to 50 metres) etc. Contact your Clarke dealer for further
information.
ABRASIVE DISCS
Replacement abrasive discs (self adhesive - 6" (150mm) dia) are available
from your CLARKE dealer:
Fine
Medium
Coarse
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Part no. 6502097
Part no. 6500809
Part no. 6502102
10