Directed Electronics 6000 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Autoalarm Directed Electronics 6000 herunter. Directed Electronics 6000 20 Seiten. Directed electronics, inc. owner's guide

Seite drucken

Diagnostics

The microprocessor at the heart of your system is constantly monitoring all of

the switches and sensors connected to it. It detects any faulty switches and

sensors and prevents them from disabling the entire system. The micro-

processor will also record and report any triggers that occurred during your

absence.

Arming Diagnostics

If the system is armed with an input active (door open, sensor triggering, etc.)

the unit will chirp once when arming and then one more time a few seconds

later. This is called Bypass Notification.

NOTE: Bypass notification will not occur when using Silent Mode

grammed OFF.

The system will ignore the input that was active when it was armed until it

goes away. Three seconds later it will monitor that input normally. For exam-

ple, if your car has interior light exit delay, and you arm the system before the

interior light goes out, you may get Bypass Notification. Three seconds after

the light goes out, however, the doors are monitored normally.

Disarming Diagnostics

Extra disarm chirps are the Tamper Alert. If four chirps are heard when dis-

arming, the system was triggered in your absence. If five chirps are heard, a

zone was triggered so many times that Nuisance Prevention Circuitry

bypassed that zone. In either case, the Status LED will indicate which zone

was involved (see Table of Zones section). The system will retain this informa-

tion in its memory, and chirp four or five times each time it is disarmed, until

the next time the ignition key is turned on.

or if chirps have been pro-

™

has