Clarke 7239230 Handbuch für Betrieb und Wartung - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Water Pump Clarke 7239230 herunter. Clarke 7239230 13 Seiten. Submersible pump
Seite drucken
POSITIONING THE PUMP
1. Stand the pump upright on a flat surface in the water that you want to
drain.
2. If there is sediment in the pool or
pond, place the pump on blocks,
to avoid blocking the water inlet.
3. Set the height of the pump inlet
by extending and twisting the
base (foot) if required. With the
base retracted the pump can
remove all but the remaining 10
mm of water.With the base
extended the pump can pick up
more solids in suspension.
4. Ensure the pump is positioned with adequate space - minimum base area
of 20 x 25 cm and the maximum depth of any installation - 7 metres (23ft).
The pump is supplied with 10 metres of power cable.
5. Always raise and lower the pump using the lifting handle and a rope
attached to it if required. Never lift or lower the pump using the power
cable.
• The water inlet must be fully submerged before the pump is switched on
and the pump be standing upright.
• You can keep the pump clear of sediment by standing it on a platform
or brick or by suspending it at a suitable depth.
6. Connect the power cable to a high sensitivity residual current device
(RCD) which has a tripping current of less then 30mA.
OPERATING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
1. Switch the mains power supply on.
• The pump will begin to drain water.
• As the water level falls, so will the float switch, until it stops the pump.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7