Acora Acoustics SRC-2 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Acora Acoustics SRC-2 herunter. Acora Acoustics SRC-2 8 Seiten. Floorstanding speaker
Seite druckenUnpacking and Initial Placement
Each Acora Acoustics loudspeaker has been inspected and packaged with pride.
Please verify that both crates are in good condition and the serial numbers are
consecutive.
We do not suggest unpacking the SRC-2 alone. Have your dealer or consultant perform
or at least assist with this process. The SRC-2 is quite heavy and should not be moved
without qualified assistance.
1) Remove the speaker from the crate per the instructions on the crate
2) Use caution not to grasp the speaker near the drivers as you could damage them.
3) Visually inspect the speaker for any transit damage.
4) Place the speakers on level flooring. For initial positioning, place the speakers parallel
to the rear wall, roughly the same distance between them as they are to the main listening
position (if you sit 12' back from them, start with the speakers 12' apart if possible unless
side walls prevent it) Typically, the speakers will image best when not towed in.
6) Connect your speakers to your amplifier and perform initial listening tests. This very well
may not be their final position. (See page 4)
7) Once you believe placement is close, install the speakers feet and spikes. The spikes
will also allow you to ensure the speakers are level. If the speakers are not level, using
a hex key, adjust the spikes until the speaker is level and stable (it should not rock from
back to front or side to side.
(if desired on hard surfaces, use the supplied spike pucks to avoid damage to flooring
due to the spikes)
8) Once level and stable, screw on the spike caps.
Listen and enjoy. You may find over time that you want to re-adjust speaker placement,
again, please do not attempt this alone.