Directed Electronics K10 Installationshandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Installationshandbuch für Autoalarm Directed Electronics K10 herunter. Directed Electronics K10 16 Seiten. Directed electronics, inc. installation guide
Seite drucken
Channel Number
Function
1
Arm/Disarm/Panic
2
Silent Mode/Remote Override/Trunk Release
3
Remote engine start or Other Accessory
4
Arm only
5
Disarm only
6
Panic only
7
Auto-learn Single Button Arm/Disarm Configuration*
8
Auto-learn Standard Configuration*
9
Delete all remotes
**NOTE: For Auto Learn Configurations, see Remote Configurations section of this guide.
Channels #4-6: Channels 4 through 6 are used to assign the arm, disarm and panic functions to sep-
arate buttons on the remote control. Teaching a button to Channel 4 erases all information about that
remote from memory. Any auxiliary functions that are desired will have to be reprogrammed. Similarly,
if the remote is set up to use the separate arm, disarm and panic channels and a button from that
remote is entered into channel one, the remote will be erased from memory, and the system will only
recognize the button that was entered into Channel 1.
Channel #9: If any button from a known remote is programmed to Channel 9, all remotes will be
erased from memory and the system features will revert to the default settings. This is useful in cases
where the one of the customer's remotes is lost or stolen. This will erase any lost or stolen remotes from
the system's memory. It can also be used to start from scratch if the remote buttons were programmed
incorrectly.
To exit the learn routine:
One long horn honk indicates that programming has been exited.
Ignition is turned off.
Override switch is pressed too many times.
More than 15 seconds elapse between steps.
Wire Color
RED/WHITE
13