Clarke CM1 Betriebs- und Wartungsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Water Pump Clarke CM1 herunter. Clarke CM1 15 Seiten. Engine driven water pump

Seite drucken

PREPARING THE PUMP FOR OPERATION

A. GENERAL.

Always prepare the site beforehand.

Ensure there is an adequate, firm foundation on which the pump may be located,

and as near the water source as possible.

Ensure there is adequate drainage for the discharged water, and that there is no

danger of damage to property as a result of the pumping operation.

B. THE ENGINE.

Fill the fuel tank with fuel as follows:

Mix: 25 parts Unleaded Petrol to 1 part 2-Stroke Oil

1. Observe ALL necessary precautions when handling petrol.

2. Never run the engine in an enclosed space - ensure there is adequate

ventilation.

C. THE PUMP

Place the unit on a firm level foundation, putting it as near as possible to the

water source, and ensure it is anchored where necessary, to prevent it from

moving during operation.

Connect the suction hose to the inlet port, using the adapter provided, ensuring

the rubber seal is in place.

NOTE: 25mm or 20mm ID hose may be used...appropriate connectors are provided.

The hose must be completely sound, there must be no damage of any kind.

The connection at the pump body, and all other connections, should there

be any, must be air tight.

Hoses or pipes should he supported independently and not carried by the

pump.

Flexible hose MUST be used at the pump connections

IMPORTANT : An air leak in the suction line will reduce the capacity of the pump.

The vast majority of problems which may occur, are as a result of air leaks in the

suction line.

Use Clarke 2 stroke oil....Part No.3050870

WARNING:

25:1