Alemite 9911-R1 Servicehandbuch für Eigentümer - Seite 5
Blättern Sie online oder laden Sie pdf Servicehandbuch für Eigentümer für Water Pump Alemite 9911-R1 herunter. Alemite 9911-R1 16 Seiten. High-pressure stripped pump
Auch für Alemite 9911-R1: Service-Handbuch (12 seiten), Service-Handbuch (12 seiten)
Seite drucken
10 Secure the piston to the rod with roll
pin (20).
Step for all models except 9911-1
9 Screw the piston assembly onto the
extension until the pin holes align.
10 Secure the piston to the extension with
roll pin (20).
11 Screw primer rod (34) into the piston
assembly until the pin holes align.
12 Secure the piston assembly to the
primer rod with roll pin (25).
13 Install and seat bearing (26), seal (27)
[heel end first], and additional
bearing (26) into the externally threaded
end of lower tube (29).
14 Install and seat gasket (28) into the
internally threaded end of upper
tube (18).
15 Screw the lowertube [with Loctite 222]
into the uppertube. Follow the thread
sealant manufacturer's recommenda-
tions.Do not tighten at this time.
NOTE
If a primer is used with Loctite 222, the
curing time is greatly reduced.
16 Install the rod assembly into the upper-
tube until it protrudes from the lower
tube.
17 Use care not to damage the seal.
18 Install seal (31) [heel end first] into foot-
valve (32).
19 Install stop (30), the footvalve assembly
[seal end first], gasket (28), seat (33)
[small diameter end first], and additional
gasket (28) over the primer rod and into
the lowertube.
20 Install primer disk (35) onto the primer
rod.
21 Make sure the hole align.
22 Install roll pin (36) that secures the
primer diskto primer rod.
23 Screw primer body (37) [with loctite 222]
into the lower tube. Follow the thread
sealant manufacturer's recommenda-
tions. Do not tighten at this time.
CAUTION
Install the rod and tube assembly into the
body with a twisting motion. Use care not to
damage the seals
Pump tube assembly - section view
24 Install the rod and tube assembly into
the body and at the same time screw the
uppertube [with Loctite 222] into the
body.
25 Follow the thread sealant manufactur-
er's recommendations.
26 Tighten all the threaded pump tube
components into one another.
5
Fig. 4