Clarke HIPPO Jr Betriebs- und Wartungsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Water Pump Clarke HIPPO Jr herunter. Clarke HIPPO Jr 6 Seiten.

MAINTENANCE

Before checking the condition of the pump, ensure it is unplugged from the

mains supply. If the unit is hard wired, ensure the circuit breaker is open.

Check the pump installation regularly to ensure the base inlet is clear of leaves or

other debris.

These pumps should require no maintenance other than regular cleaning. If the

pump starts to show signs of wear or damage, contact your CLARKE dealer for

advice. Do not use the pump if there is any damage to the mains supply cable, or

to the float switch or its cable. Do not attempt to repair the pump yourself, as you

may damage the waterproof seal and invalidate your guarantee. Repairs must

be carried out by your CLARKE dealer, or contact the CLARKE Service Department,

on 020 8988 7400

Motor ................................................................ 230V 50Hz 1Ph.

Motor Output ................................................... 180Watts

Head Max. ....................................................... 5.5 Metres

Minimum suction level .................................... 5mm

Maximum imersion depth ............................... 5M

Max. Flow Rate ................................................ 70 L/min

Max. Water temp. ........................................... 35°C

Outlet Fittings ................................................... 1" BSP Threaded

Dimensions ....................................................... 160x210mm

Duty Cycle ....................................................... S3 - 2Hrs*

Part No. ............................................................. 7230490

* Duty Cycle = 2 Hours ON, followed by 1 hour OFF

Head

in Metres

WARNING

................................................. 19mm (¾")

................................................. 25mm (1")

Flow Rate Chart

Flow Rate - Litres/min