Directed Electronics AS-1272 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fernstart Directed Electronics AS-1272 herunter. Directed Electronics AS-1272 12 Seiten.

Seite drucken
Directed Electronics AS-1272 Benutzerhandbuch
Using the Remote Control 
Your Remote Car Starter is equipped with a 2-button multi-channel remote control that can be
configured into 2 different functions.
Default remote function:
•
button: STOP;
•
button: START;
•
&
buttons (together): TRUNK release.
Alternate programmable remote function:
•
button: LOCK/UNLOCK;
•
button: START/STOP;
•
&
button (together): TRUNK release.
Vehicle Presets 
Heater 
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on HIGH. It
is recommended to leave the settings on LOW or MEDIUM instead.
Windshield Wipers, Radio & Headlights 
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are OFF. Leaving the headlights switch ON on certain
types of vehicles could cause them to remain ON even after remote starter shutdown, resulting in a
dead battery.
Remote­Starting Your Vehicle 
Setting Your Vehicle into Ready Mode 
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
P.4
User Guide