Clarke HSEC1400A Handbuch für Betrieb und Wartung - Seite 5
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Water Pump Clarke HSEC1400A herunter. Clarke HSEC1400A 17 Seiten. Submersible sewage cutter pump
Seite drucken
USING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
WARNING: THE WATER BEING PUMPED WILL BE POLLUTED IF THIS PUMP
BECOMES DAMAGED AND LUBRICANT WITHIN THE PUMP ESCAPES.
1. Using the adaptor if required,
connect a suitable hose (not
supplied) to the pump outlet.
• Suitable hoses are available from
your local Clarke dealer.
2. Place the pump vertically on a flat
surface in the area that you want to
drain.
• If there is sediment in the area,
place the pump on house bricks,
or similar.
• Ensure the pump is positioned with adequate space so that the
movement of the float switch is not restricted - recommended minimum
area of 50 x 50 cm.
• ALWAYS raise and lower the pump using a rope attached to the lifting
handle.
• Take all necessary precautions as described on page 3.
• The pump inlet must be fully submerged before the pump is switched on.
3. Connect the mains plug to a high sensitivity residual current device (RCD)
which has a tripping current of less then 30mA.
4. Switch the mains power supply on.
• The pump will begin to drain water.
• As the water level falls, so will the float switch, until it stops the pump.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5