Clarke PSP195 Handbuch für Betrieb und Wartung - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Water Pump Clarke PSP195 herunter. Clarke PSP195 13 Seiten. Puddle pump

ELECTRICAL CONNECTIONS

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS

SUPPLY.

These pumps MUST be fitted with a Residual Current Device (RCD), with a

rated residual operating current of no greater than 30mA. This is essential

when the pump is used for pumping swimming pools.

The mains lead must be connected to a standard 230 volt (50Hz) electrical

supply through an approved plug or a suitably fused isolator switch.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE

COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

BLUE = NEUTRAL

As the colours of the flexible cable of this appliance may not correspond with

the coloured markings identifying terminals in your plug proceed as follows:

• The BLUE wire must be

connected to the

terminal which is

marked N.

• The BROWN wire must

be connected to the

terminal which is

marked L.

• The YELLOW AND

GREEN wire must be

connected to the

terminal which is

marked E or

In the event that the pump is hard-wired into the electrical system, it must be

carried out in accordance with IEE regulations.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

BROWN = LIVE

Plug must be BS1363/A approved.

Earth

(Green and

Yellow)

Neutral

(Blue)

YELLOW AND GREEN = EARTH

Ensure that the outer sheath of

the cable is firmly held by the clamp

Always fit

a 13 Amp

fuse.

Live

(Brown)