Directed Electronics PS-4461TWE-FM Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fernstart Directed Electronics PS-4461TWE-FM herunter. Directed Electronics PS-4461TWE-FM 20 Seiten. Two-way 6-button lcd automatic/manual transmission remote starter

Seite drucken

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If your vehicle has an automatic transmission, proceed as follows to set the system to Turbo
Mode:
1.
With the engine running, make sure to release the brake pedal and press the
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
button; this will lock the doors, arm the OEM-style alarm (if configured|)
and confirm that the vehicle is in Turbo Mode.
5.
The engine will shut down after 60 seconds.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-9) to
activate Turbo Mode. At the last step,
x
Press
to lock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
The OEM-style alarm and starter kill (if configured) will be armed.
x
Press
to unlock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
x
Press
to shut down the engine without affecting the doors.
Note: The vehicle will enter Ready Mode once the engine run time expires.
"Home Valet
TM
" Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote, but the
OEM alarm functions will remain active.
To take the system into home valet mode:
1.
Press the
or
button.
2.
Within 3 seconds, press the
and
once and display
icon on the LCD screen.
To take the system out of home valet mode:
x
Turn the ignition key to the IGNITION ON (RUN) position.
The system will warn you if someone attempts to start your vehicle while it stands in home valet
mode. The parking lights will:
Turn ON then OFF; then
Flash twice, pause; then
Flash twice again.
User Guide
,
buttons simultaneously until the transmitter beep
P.15
or