Alemite 7836-A Service-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Service-Handbuch für Kontrolleinheit Alemite 7836-A herunter. Alemite 7836-A 8 Seiten.

Seite drucken

SER 7836-A

7. Screw Packing Nut (15) into the Body.

• Do not tighten the Nut at this time.

8. Install Link (16) onto the pins of the Handle.

Steps for Model 7836-A

9. Install Valve Assembly (4) onto the Rod.

• Make sure the holes are in alignment

10. Install Pin (3) that secures the Valve Assembly to the

Rod.

Step for Model 7836-C1

11. Screw Valve Assembly (7) onto the Rod [with

™

Loctite 222

HINT: Screw Nut (17) and Guide (20) onto

the Rod. Use the Guide to jam the Nut.

CAUTION

Install the Rod assembly with care. Use care

passing the Leather washer and O-Rings. Damage

to the Components can occur.

12. Install the Rod assembly into the front of the Body.

• Allow the Rod to travel through the Packing Nut and

just past the Link.

13. Install Nut (17) [round side first] onto the Rod.

• Screw the Nut almost to the end.

14. Drop Guide (20) through the rear portion of the Body

and onto the Rod.

15. Screw the Guide onto the Rod.

• Do not allow the Guide to contact the Nut.

16. Install and seat Spring (19) into the Body and into the

Guide.

17. Screw Adapter (18) into the Body.

• Tighten the Adapter securely.

18. Install Gasket (1) onto Valve Seat (2 or 6).

19. Screw the Valve Seat assembly into the Body.

• Tighten the Valve Seat securely.

Revision (1-13)

1-800-548-1191 - http://www.partdeal.com - [email protected]

Adjustments

Handle Adjustment

20. Adjust the Nut on the Rod until the Handle moves

freely 1/8 " (3.2 mm) at the bottom.

• See Figures 3 and 4.

IMPORTANT: The Rod may rotate with the

Nut during this procedure. Should this occur,

insert the Adjusting Pin into the Packing Nut

and tighten.

21. Tighten the Guide against the Nut.

O-Ring Compression

22. Using Adjusting Pin (26), tighten the Packing Nut into

the Body until it just begins to drag.

23. Tighten the Packing Nut 1/6 of a turn (one hole

position) further.

Installation

IMPORTANT: Apply thread sealant to all

pipe thread connections prior to assembly.

1. Connect the components of the extension assembly

(not included) and tighten securely.

2. Attach the delivery line to the Swivel Assembly.

• Tighten the connection securely.

Figure 4

Handle Free-Play Adjustment

and O-Ring Compression

Control Valve

Alemite LLC