Directed Electronics Xpresskit DBALL Installationshandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Kraftfahrzeuge Directed Electronics Xpresskit DBALL herunter. Directed Electronics Xpresskit DBALL 14 Seiten. Databus all combo bypass module
Auch für Directed Electronics Xpresskit DBALL: Installationshandbuch (14 seiten)
Seite drucken
Platform: DBALL/DBALL2
Firmware: GM5 Remote Start Ready (RSR) Installation
For vehicles equipped with an automatic transmission, put the transmission in
5
Park (P position).
6
You can remove the key, the module is now programmed and ready to operate.
You have successfully completed the module programming sequence.
Module Reset
A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
If required for your installation, connect the 10-pin & 12-pin
1
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the
2
programming button. The LED turns ON solid red.
Hard Reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as RFTD and D2D options) may have to be reconfigured. See the Feature & Option List section of this guide.
If required for your installation, connect the 10-pin & 12-pin
1
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds
2
until the LED starts to flash orange and red.
3
Release the programming button. The LED turns ON solid red.
Key OUT
th
4
nd
st
2
1
&
Solid
Release
th
4
nd
st
2
1
Solid
Release
© 2015 Directed. All rights reserved.
Rev.: 20150626
Page 6
Position
"P"
START
rd
3
&
Solid
rd
3
&
Flashes
&
Solid