Directed Electronics Viper Audio 400.2 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Directed Electronics Viper Audio 400.2 herunter. Directed Electronics Viper Audio 400.2 16 Seiten. Direct electronic power amplifier owner's manual

Seite drucken

FRONT PANEL CONNECTIONS/STATUS LED

1. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass

through RCA jacks can be used to

send a signal to a second amplifier.

2. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level

outputs from head units or signal

processors at voltages between

150mV and 8 volts.

FIGURE 1—AMPLIFIER CONNECTIONS 400.2 FRONT

REAR PANEL CONNECTIONS

1. S S p p e e a a k k e e r r O O u u t t T T e e r r m m i i n n a a l l s s - Connect

the speakers to these terminals.

(Refer to the Speaker Connection

section of this guide.)

2. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal

turns on the amplifier when (+) 12

volt is applied to it. Connect it to

the remote turn on lead of the head

unit or signal source. If a (+) 12

volt remote turn lead is not avail-

able, a Remote Power Adapter

3. S S t t a a t t u u s s L L E E D D - Will light green to indi-

cate the amplifier is on and oper-

ating normally and will be off if the

amplifier shuts down due to short

circuit, DC offset, or overheating

detected by on-board protection

circuitry.

(P/N #55000) can be used to

supply a remote turn on signal. DO

NOT connect this terminal to

constant (+) 12 volt.

3. P P o o w w e e r r F F u u s s e e s s - These fuses protect

the amplifier against internal elec-

trical damage and are meant to

protect the amplifier only. All other

power connections should be fused

at the source.