CTEK CHARGESTORM CONNECTED 2 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Ladegerät für Autobatterien CTEK CHARGESTORM CONNECTED 2 herunter. CTEK CHARGESTORM CONNECTED 2 19 Seiten.
Auch für CTEK CHARGESTORM CONNECTED 2: Benutzerhandbuch (20 seiten)
Seite drucken
To install the network cable and the
3G-modem (optional)
G
A
Controller board
E
3G-modem
F
U.FL Antenna
B
RJ45
contact
C
USB
G
SIM-card slot
D
Mini-USB
If the charging station shall be connected to
NanoGrid
TM
- Load balancing, or to the Charge Portal
- The cloud based charging portal online, do the
steps that follow.
•
Enclose the network cable with the attached
insulation cable. The network cable in the
powerbox needs extra insulation for electrical
safety reasons.
•
If the charging station is behind a firewall and
will be connected to a backend system, open
DNS (port 53) and https/wss (port 443) in
the firewall. Open ftp to allow remote firmware
upgrades.
CTEK E-Mobility AB
F
E
D
C
B
A
•
If Ethernet shall be connected, use a network
cable of type Cat5 or better. Connect the
network cable to the RJ45 connector on the
control board. The control board is located
on the front panel. When the network cable
is connected the activity LED in the RJ45
connector activates.
•
If 3G shall be connected, install an activated
SIM card in the charging station. The PIN
must be disabled and the subscription with
recommendation of a minimum of 2 GB/
month depending on the OCPP protocol
communication from the operator. Make sure
that the antenna cable is attached in both
ends.
NOTE: Some operators have installed the SIM card
at the factory.
User & installation instructions
To finish the installation
Mini SIM
15x25mm
1.
Install the protection cover.
2.
Close and lock the technical box with the key.
3.
Put the cover on the key lock.
4.
Turn on the power from the distribution panel.
NOTE: It may take one to two minutes for the charger
to start.
7