Directed Video OHC100 Installationshandbuch des Eigentümers - Seite 10

Blättern Sie online oder laden Sie pdf Installationshandbuch des Eigentümers für Car Video System Directed Video OHC100 herunter. Directed Video OHC100 16 Seiten. Directed video car video system user manual

Seite drucken

CUTTING THE HEADLINER

Insert a pick tool or pin through the

cutout templates center point indicator

and the center point mark on the headlin-

er to align the cutout template with the

center of the vehicle.

Sight down the center of the vehicle from

the rear and align the template so it runs

square to the vehicle and other interior

components.

Make sure the arrows point toward the

front of the vehicle. Attach the template

to the headliner using masking tape.

Using both hands for control, cut the

headliner with a razor or sharp knife, being

careful not to slip. DO NOT cut past the heavy

line marked CUT LINE. It is the maximum cut

size when using the trim ring for installation.

The only time the headliner should be cut

past this line is when the monitor mount is

being installed directly to the headliner

without the use of the trim ring.

NOTE: For extra support it is suggested that the minimum

amount of the headliner be removed.

INSTALL THE MOUNTING PLATE

After removing the headliner cutout, thor-

oughly clean the inside sheet metal of the

vehicle roof with a degreaser so no dust or

residue remains. This will allow the mount-

ing posts to securely adhere to the vehicle

roof. Extremes in temperature can diminish

the life of some adhesives allowing the

overhead monitor to vibrate or come loose.

NOTE: When installing the mounting plate it is always

advisable to use any available metal roof sup-

ports in conjunction with the mounting posts.

Place the mounting plate against the vehicle

roof or headliner and mark the location of

the slotted holes that will give the most sup-

port. As with the template, make sure the

position of the mounting bracket is square to

the vehicle and interior components.

Using these marks as a guide, remove the

double-stick tape from the mounting posts

and apply to the vehicle roof. Position the

mounting posts at the approximate center

of the slotted holes. This will allow for

maximum adjustability during the final

mounting of the OHC100. After adhering

the mounting posts to the vehicle roof it is

recommended that a generous bead of sil-

icone be applied to their base at the point

of contact with the roof.

NOTE: Take care not to dimple the vehicle exterior or punc-

ture the roof sheet metal when tightening screws.