Clarke RA40 Bedienungsanleitungen
Blättern Sie online oder laden Sie pdf Bedienungsanleitungen für Bodenmaschine Clarke RA40 herunter. Clarke RA40 2 Seiten.
Seite drucken
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
External battery charger
2. Fill the tank with clean water. The
1a. Unplug the battery charger cord.
Reconnect it to the machine.
Onboard battery charger
1b. Disconnect the battery charger cord
from the electrical outlet.
6. Insert and rotate the operator key,
7. Push the drive pedal to start cleaning.
then start the machine by pressing
the One-Touch button. To engage
the brush, slightly press the pedal
speed and then release it.
At the end of use
10. Machines with Chemical Mixing
11. Empty the recovery tank with the
System: Always turn off the detergent
2 minutes before finishing by pressing
the detergent button to rinse out
detergent from the system and brush
before handling and cleaning.
14. Take the squeegee off and remove
15. Clean the machine using a damp
debris. Check and clean the
squeegee blades.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS.
9435 Winnetka Avenue North
•
Brooklyn Park, MN 55445
Phone: 800.253.0367
•
Fax: 800.825.2753
240 Superior Boulevard
•
Mississauga, Ontario, Canada L5T 2L2
Phone: 800.668.8400
•
Fax: 800.263.5111
3. For machine equipped with Chemical
water temperature must not exceed
Mixing system: Mount the tank with
40° C.
a detergent suitable for cleaning
Make sure the solution valve under
machines (highly concentrated and
the machine is open.
low foaming detergent)
8. To change the solution flow level
Adjust the speed by applying
push the solution button and
pressure to the drive pedal.
change the flow level according to
For the reverse mode press the
desired cleaning performance and
green button.
application.
12. Empty the debris tray and clean/
hose. Then empty the solution tank
with the transparent hose.
16. Charge the batteries: Connect
cloth and when needed use a
neutral cleaning product.
Operating Guidelines
4. Install the squeegee and fasten it
with the knob.
9. If necessary press the vacuum button
for stop/start vacuuming.
13. Clean the filter:
wash the recovery tank inside.
A) Close the solu tion valve under
B) Remove the transparent cover and the
C) Reassemble the filter.
17. Park the machine keeping the
recovery tank cover open and hang
the battery charger cord to the
electrical outlet.
the squeegee.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
15. Remove to clean or change brush.
the machine.
gasket, then remove and clean the
filter inside.
RA40
™