Clarke 3120181 Betriebs- und Wartungsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Säge Clarke 3120181 herunter. Clarke 3120181 17 Seiten. Sabre saw

OPERATION

OPERATING THE SAW

1. Adjust the work guide as required

as shown on page 7.

2. Slide the safety lock forward and

squeeze the trigger. Allow the saw

to reach full speed before use.

3. Release the trigger to stop the

saw. When the blade has stopped

remove it from the workpiece.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the air supply has been shut

down and the compressed air released from the hose.

• Refer to the compressor instruction manual for the procedure to shut

down and release the compressed air.

• Once the pressure has been released, disconnect the air supply

hose from the saw.

WARNING: MAKE SURE THAT THE SAW IS DISCONNECTED FROM THE AIR

SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

Please note that factors other than the tools condition may effect its operation

and efficiency, such as reduced compressor output, excessive drain on the

airline, moisture or restrictions in the air-line, or the use of connector

DAILY

1. Before use, drain water from the air-line and compressor.

2. Lubricate the saw daily for optimum performance. Use a high quality airline

oil either via a lubricator in the air supply system or by placing a few drops

into the air inlet immediately before use. This should be carried out

regardless of whether or not an in-line lubricator is used.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]