Clarke 6470162 Handbuch für Betrieb und Wartung - Seite 11
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Säge Clarke 6470162 herunter. Clarke 6470162 17 Seiten. 355mm abrasive cut-off saw
Seite drucken
DEPTH STOP
The depth stop is set at the factory for
a new 14" (355mm) cutting disc. This
can be adjusted as the disc wears.
1. Loosen the jam nut.
2. Loosen the depth stop bolt.
3. Adjust the bolt to desired height.
4. Then turn the jam nut until seated
firmly against the saw arm casting.
• Securely tighten the depth stop
bolt before use.
CAUTION: WHEN CHANGING TO A NEW CUTTING DISC, READJUST THE
DEPTH STOP TO THE ORIGINAL POSITION TO PREVENT CUTTING INTO THE
SUPPORTING SURFACE.
MAINTENANCE
CLEANING
CAUTION: NEVER USE SOLVENTS OR OTHER HARSH CHEMICALS FOR
CLEANING THE NON-METALLIC PARTS OF THE TOOL. THESE CHEMICALS
MAY WEAKEN THE PLASTIC MATERIALS USED IN THESE PARTS.
Use a cloth dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Occasionally blow dirt and dust out of motor air vents with clean, dry air. To
minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this task.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11