Clarke WOODWORKER CBS250 Betriebs- und Wartungsanleitung - Seite 5
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Säge Clarke WOODWORKER CBS250 herunter. Clarke WOODWORKER CBS250 20 Seiten. 45 mm (10”) bandsaw & stand
Auch für Clarke WOODWORKER CBS250: Handbuch für Betrieb und Wartung (13 seiten)
Seite drucken
14. ALWAYS wear proper apparel. loose clothing or jewellery may
get caught in moving parts. wear protective hair covering to
contain long hair.
15. ALWAYS use recommended accessories. the use of improper
accessories could be hazardous.
16. ALWAYS remove plug from electrical outlet when adjusting,
changing parts, or working on the machine.
17. NEVER operate machine while under the influence of drugs, alcohol or any medication.
18. NEVER leave machine running unattended. turn power off.
Do not leave the machine until it comes to a complete stop.
19. NEVER force the machine. it will do a better and safer job at
the rate for which it was designed.
20. NEVER use power tools in damp or wet locations or expose
them to rain. Keep your work area well illuminated. do not
use in explosive atmosphere (around paint, flammable liquids
etc). Avoid dangerous environment.
ADDITIONAL PRECAUTIONS FOR BANDSAWS
1.
ALWAYS check safety guards are in place and functioning correctly before switching
the machine ON.
2.
ALWAYS use a push stick, especially on small workpieces.
3.
ALWAYS use the appropriate saw blade for the material being cut.
4.
DO NOT use the machine if the electric cable, plug or motor is in poor condition.
5.
DO NOT allow the ventilation slots in the motor to become blocked.
6.
DO NOT touch the blade immediately after use, when changing blade always allow
time for it to cool.
7.
DO NOT use bent or cracked blades. (Replacement blades are
available from your CLARKE dealer.
8.
Replace table insert if slot has become enlarged.
9.
When cutting wood, ensure all nails have been removed
beforehand. Nails will damage the saw blade.
10. When cutting boards in upright position use a suitable push
block to prevent kickbacks
11. When cutting round stock, use a suitable jig or fixture to keep
the work from turning.
12. Ensure the blade is fully tightened and correctly adjusted
before use.
13. Keep the mains cable well away from the machine and
ensure an adequate electrical supply is close at hand so
that the operation is not restricted by the length of the cable.
14. Switch the machine OFF immediately the task is completed.
Additionally, please keep these instructions in a safe place for future reference.
5
5