Clarke CONTRACTOR DEVIL 351C Betriebs- und Wartungsanleitung - Seite 8
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Heizgerät Clarke CONTRACTOR DEVIL 351C herunter. Clarke CONTRACTOR DEVIL 351C 17 Seiten.
Seite drucken
OPERATION
WARNING: FOR SAFE OPERATION OF THIS HEATER IT IS ESSENTIAL TO READ
THESE INSTRUCTIONS BEFORE USE.
WARNING: PLEASE NOTE THAT THE HEATING ELEMENTS OF THIS PRODUCT
DO NOT GLOW WHILST IN OPERATION. ANY PICTURES SHOWING THIS IN
ADVERTISING MATERIAL ARE FOR ILLUSTRATION ONLY.
USING THE REMOTE CONTROL
All operations must be done using the
remote control.
• 2 x AAA batteries are required
and are installed as shown by
the diagram found inside the
control unit.
• The remote control must be
directed at the heater display
panel. It has a range of approx
2.5 metres and must be aimed
at the correct angle.
• The function of each button on
remote control is the same as
operation panel.
MANUAL OPERATION
1. Stand the heater on a firm, level surface and following all safety
precautions, connect to a suitable power supply.
• The heater is equipped with an anti-tilt switch that automatically
cuts the power off should the heater tip over. If this happens, stand
the heater upright and it will immediately re-set.
2. Switch on the power at the primary
switch.
• The heater will be in Standby
with the display showing PO.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8