Lenovo IdeaTab S2110 Hardware-Wartungshandbuch - Seite 25

Blättern Sie online oder laden Sie pdf Hardware-Wartungshandbuch für Tablette Lenovo IdeaTab S2110 herunter. Lenovo IdeaTab S2110 46 Seiten. Ideatab s2110a hardware maintenance manual v1.0
Auch für Lenovo IdeaTab S2110: Handbuch (19 seiten)

Seite drucken

Lenovo IdeaTab S2110 Hardware-Wartungshandbuch

Power system checkout

To verify a symptom, follow the steps below:

1. Turn off the computer.

2. Remove the battery pack.

3. Connect the AC adapter.

4. Make sure that power is supplied when you turn on the computer.

5. Turn off the computer.

6. Disconnect the AC adapter and install the charged battery pack.

7. Make sure that the battery pack supplies power when you turn on the

If you suspect a power problem, see the appropriate one of the following power

supply checkouts:

• "Checking the AC adapter" on page 21

• "Checking operational charging" on page 21

• "Checking the battery pack" on page 22

Checking the AC adapter

You are here because the computer fails only when the AC adapter is used.

• If the power-on indicator does not turn on, check the power cord of the AC

• If the computer does not charge during operation, go to "Checking

To check the AC adapter, follow the steps below:

1. Unplug the AC adapter cable from the computer.

2. Measure the output voltage at the plug of the AC adapter cable. See the

Note: Output voltage for the AC adapter pin No. 2 may differ from the one you

are servicing.

3. If the voltage is not correct, replace the AC adapter.

4. If the voltage is acceptable, do the following:

• Replace the system board.

• If the problem continues, go to "Lenovo IdeaTab S2110A" on page 24.

Note: Noise from the AC adapter does not always indicate a defect.

Checking operational charging

To check whether the battery charges properly during operation, use a

discharged battery pack or a battery pack that has less than 50% of the total

power remaining when installed in the computer.

computer.

adapter for correct continuity and installation.

operational charging".

following figure:

Voltage (V DC)

+20

General checkout