Lenovo TAB 10 Sicherheit, Garantie und Schnellstartanleitung - Seite 12
Blättern Sie online oder laden Sie pdf Sicherheit, Garantie und Schnellstartanleitung für Tablette Lenovo TAB 10 herunter. Lenovo TAB 10 15 Seiten.
Auch für Lenovo TAB 10: Sicherheit, Garantie und Schnellstartanleitung (33 seiten), Benutzerhandbuch (24 seiten)
Seite drucken
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modi cations not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the United States.
During SAR testing, this device is set to transmit at its highest certi ed power level in all
tested frequency bands, and placed in positions that simulate RF exposure in usage
near the body. Although the SAR is determined at the highest certi ed power level, the
actual SAR level of the while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output.
The exposure standard for wireless employs a unit of measurement known as the
Speci c Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.