CTX VL950S Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Monitor CTX VL950S herunter. CTX VL950S 14 Seiten. Ctx vl950s: user guide

Trouble-Shooting

Section 4

Before calling an authorized service center, please check that the items

below are properly connected or set.

In case of using a non-standard signal, please check the pin assignments

and the signal timing of your adapter with the specifications outlined on

section 2.1 and 2.2.

Problem

No picture

"No Signal Input" is displayed on

screen

Display image is not centered,

too small, or too large

Image is scrolling or unstable

Picture is fuzzy

Picture bounces or a wave

pattern is present in the picture

Edges of the display image are

curved either inward or outward

Color looks blotchy

No Plug & Play

Power Switch should be in the ON position and the power cord should be connected.

Check the color of the power LED indicator, if it is orange, then the monitor is in

the power saving mode.

Check the horizontal/vertical frequency if out of range.

Maximize the Brightness and Contrast controls.

The video card should be completely seated in its slot.

Computer power switch should be in the ON position.

The signal cable should be completely connected to the video card/computer.

Adjust Position and Size controls to adjust the image.

Signal cable should be completely attached the computer.

Check the pin assignments and signal timings of the monitor and your video card.

Adjust the Contrast and Brightness Controls.

Push the degauss button once.

CAUTION: A minimum interval of 20 minutes should exist before the degauss

button is used a second time when not switching between modes.

Do not hold the button down continuously

Move electrical devices that may be causing electrical interference away from the monitor

See the inside front cover of this manual for FCC information.

Adjust the Pincushion control.

Press the degauss button once.

heck if hosting system is Plug Play compatible.

heck if VGA card is DDC 1/DDC 2B compatible.

heck if Window '95 is installed, and the software key for DDC function is enabled.

heck if original maker's detachable signal cable is being used(D-15 only).

Items to check