Dirty hand 100481 Betriebshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Holzspalter Dirty hand 100481 herunter. Dirty hand 100481 16 Seiten. 5-ton electric log splitter

Seite drucken

Repair and Maintenance

• Do not operate the log splitter when it is in poor mechanical

condition or in need of repair. Frequently check that all nuts,

bolts, screws, hydraulic fittings and hose clamps are tight.

• ALWAYS unplug the power cable before performing any

maintenance and repair.

• Do not alter the log splitter in any manner. Any alteration will

void the warranty and could cause the log splitter to be unsafe to

operate.

• Do not tamper with the engine to run it at excessive speeds.

The maximum engine speed is preset by the manufacturer and is

within safety limits.

• NEVER adjust the hydraulic valve. The system is preset at the

factory and is within safety limits.

• ALWAYS check the level of hydraulic oil before operation.

• ALL replacement parts must meet manufacturer's

specifications.

• ALWAYS repair or replace a damaged power cord immediately.

HYDRAULIC SAFETY

The hydraulic system of the log splitter requires careful inspection

along with the mechanical parts. Be sure to replace frayed, kinked,

cracked or otherwise damaged hydraulic hoses or hydraulic

components.

• Check for hydraulic fluid leaks by passing a piece of paper or

cardboard underneath or over the area of the leak. Do not check

for leaks with your hand. Fluid escaping from the smallest hole,

under pressure, can have enough force to penetrate the skin causing

serious injury or death.

• Seek professional medical attention immediately if injured

by escaping hydraulic fluid. Serious infection or reaction can

develop if medical treatment is not administered immediately.

• Relieve all pressure by shutting off the engine and moving the

valve control handle back and forth should it become necessary to

loosen or remove any hydraulic fitting.

• Do not remove the cap from the hydraulic tank or reservoir while

the log splitter is running. The tank could contain hot oil under

pressure which could result in serious injury.

• Do not adjust the hydraulic valve. The pressure relief valve on

the log splitter is preset at the factory. Only a qualified service

technician should perform this adjustment.

WARNING