Acorn Engineering SFST-T-OT-CWB-ITG Anweisungen für Installation, Betrieb und Wartung - Seite 5

Blättern Sie online oder laden Sie pdf Anweisungen für Installation, Betrieb und Wartung für Kontrolleinheit Acorn Engineering SFST-T-OT-CWB-ITG herunter. Acorn Engineering SFST-T-OT-CWB-ITG 8 Seiten. Sfst series thermostatic mixing valve supply fixture

Seite drucken

INSTALLATION:

1. Locate mixing valve fixture in a suitable place

accessible for servicing and adjusting. Valve

fixture should be as close as possible to point

of use.

2. Thoroughly flush supplies.

3. Connect Hot and Cold supplies to mixing valve

inlets and outlet to fixture(s). Valve fixture

connections are 1/2" NCT, for supply lines

by others.

4. Turn on supplies and inspect for leaks. Tighten

connections if leak(s) are detected.

5. Turn on fixture and allow to run until water

temperature stabilizes. Measure water

temperature. If water is not at desired

temperature adjust as needed, (refer to

adjustment section below). Maximum

recommended outlet temperature is 115°F

(46°C).

TEMPERATURE ADJUSTMENT:

1. Loosen locknut. Detail A

2. Turn on fixture so temperature can stabilize.

3. Using 1/4" allen wrench turn adjustment stem

counter-clockwise for hotter or clockwise for

colder outlet temperature. Detail B

4. Tighten locknut to prevent any unauthorized

or accidental temperature adjustment.

5. Re-check temperature.

LOCKNUT

DETAIL A

Acorn Controls

Division of Acorn Engineering Company

Manual #7802-117-000

5/8" WRENCH

SFST Installation & Operation Manual

INSTALLER

PROVIDED

1/2" NCT RISER,

SUPPLIES AND

CONNECTIONS

ADJUSTMENT

STEM

, A member of Morris Group International

TYPICAL INSTALLATION

1/8" ALLEN

WRENCH

DETAIL B

™

Page 5 of 8

Date: 09/22/17