ABBA STB15 Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Landschaftliche Beleuchtung ABBA STB15 herunter. ABBA STB15 4 Seiten. 12v landscape light specialist

Seite drucken

fixture(s) must be installed in accordance with all local codes and ordinances.

Do not instal within 10 feet of a pool, spa or fountain

To ensure optimal performance and safety, it is

important to use our fixtures ONLY with a low

voltage landscape transformer. This transformer

reduces the voltage from 120V to 12V, making it

safe and suitable for outdoor use.

When installing the fixture(s), please follow

these instructions carefully:

1.Before

installation,

the power is turned off for your safety.

2.To access the interior of the fixture, simply

loosen and remove the two front screws, which

will allow you to open the fixture. Hold the

outlet against the wall at the desired height and

orientation. Ensure it is level and aligned

according to your preferences.

3. Using a pencil or marker, carefully mark the

hole location on the wall of the outlet box.

4. Select an appropriately sized for the hole,

which should match the diameter of the outlet

box you are using.

5. Position the drill on the marked spot and

gently drill hole into the wall at the marked

location.

6. To prepare the hole required for securing the

fixture for the screws, use a pencil or marker to

meticulously mark the hole's location. Then,

utilize a drill bit that corresponds to the size of

the screws. Take care to ensure a clean and

precise hole, exercising caution throughout the

process.

7. Place the outlet box against the wall, aligning

the screw holes you created. Take the screws

and insert them through the holes in the outlet

box one at a time.

CAUTION:

INSTALLATION INSTRUCTION

please

ensure

that

www.ABBALightingUSA.com

7.For concrete installation, To begin, construct

conduit raceways inside the concrete formwork by

using one-inch dowels and PVC pipe before pouring

the concrete. After the concrete has cured, remove

the dowels and proceed to finish the outer surface

of each riser if you are installing it in stairs.

8.Using a screwdriver, tighten the screws gradually

and evenly, ensuring a secure attachment of the

metal plate to the wall. Be cautious not to

overtighten and damage the wall surface.

9.Confirm that the outlet box is firmly and evenly

attached to the wall, without any wobbling or

misalignment. Use a level to verify that the fixturel

is vertically aligned, as desired.

We recommend using WN12 waterproof wire nuts

(sold separately) for optimal connectivity.

10.Strip

the

insulation:

approximately 3/4 inch (1.9 cm) of insulation from

the ends of the two wires you wish to connect.

Ensure that the bare metal ends are clean and free

from any frayed strands.

11. Align the wires: Hold the stripped ends of the

two wires together, aligning them neatly and

ensuring that no stray strands are crossing over.

12. Insert the aligned ends of the wires into the

wire nut, ensuring that they go all the way in. The

bare ends should be completely covered by the

wire nut. Twist the wire nut: Firmly twist the wire

nut clockwise onto the wires, ensuring a secure

connection. Continue twisting until the wire nut is

tight and snug. Test the connection: Gently tug on

each wire to ensure they are securely held by the

wire nut. For added safety, it is recommended to

apply electrical tape around the wire nuts and

wires as an extra layer of protection.

13. Insert the bulb with the correct wattage.

Carefully

strip