Disc Makers Reflex1 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Computer Hardware Disc Makers Reflex1 herunter. Disc Makers Reflex1 6 Seiten. Dvd
Auch für Disc Makers Reflex1: Schnellstart-Handbuch (2 seiten), Handbuch (12 seiten), Benutzerhandbuch (9 seiten)

Seite drucken

FUNCTIONS

1. Copy Disc

• Power on the system by pressing the button on the lower right front of the unit.

You will then see the system initializing and performing a self test on the front

panel LED. The LED will show "System Check", and then switch to "1.Copy

Disc" mode automatically

• To begin the duplication operation, load the top drive (reader) with the master

disc. Load the lower drive (writer) with high quality DVD-R media.

• Press the "OK" button to begin duplicating. The system will automatically ana-

lyze the master disc, and begin duplicating at the maximum recording speed.

• LCD will display progress meter and eject the duplicated disc when completed.

If the duplication fails the disc will remain in the bottom drive.

• Writing: MM:SS (Total disc length)

• MM:SS (Actual progress)

• To continue the same duplication job, reload the writer with blank DVD-R media

and the system will start duplicating automatically again. To start a new job,

replace the original master with a new master disc.

2. Test Copy Disc

• The "Test Copy Disc" function performs the same operation as "Copy" except

that the data is not actually written onto the DVD-R media. The DVD-R disc will

remain blank when this operation is performed. This operation is used to confirm

the status of the 'Master' disc that it is capable of being read and that the whole

disc can be copied. It is also used to test the system during setup or after being

transported.

3. Copy Track

This function is a track-selecting function that can combine tracks on different DVD or

CD's into one single DVD/CD. For example, you can make a collection of favorite songs

from different music DVDs and record them to one compilation DVD.

• Load your master DVD into the DVD reader. The system will analyze the master

DVD and show the total xx tracks on the display

• Load your blank DVD-R media into the DVD writer

• Use the up and down buttons to select the tracks you want to copy and press

"OK" to select. An asterisk will come up above the track number selected. Press

"OK" again to unselect.

• When finish selecting, press down button to OK position and press "OK" button.

• LCD will display progress meter (see below) and eject the duplicated disc when

completed.

Track xx (Present track)

[MM:SS] (estimated CD Capacity)

• After finishing copying all tracks on the DVD, the system will eject the master

DVD. Insert another master disc or close the tray.

www.discmakers.com

MM:SS (Track length)

MM:SS (actual progress)

1-888-800-4041