Blade InducTrix 200 Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Quadcopter Blade InducTrix 200 herunter. Blade InducTrix 200 17 Seiten.

Seite drucken

Transmitter Setup

Program your transmitter before attempting to bind or ﬂ y

the quadcopter. Transmitter programming values are shown

below for the Spektrum DX6i, DX7s, DX6, DX7, DX8, DX9

and DX18.

The ﬁ les for models using Spektrum

™

AirWare

software are also available for download online

at www.spektrumrc.com.

Your quadcopter is also compatible with Spektrum DXe

radios with software version 1.3 or higher. Use the directions

below to reverse channel 6, or use the appropriate program-

ming cable and the PC or mobile app to program the DXe.

We recommend downloading the Blade

model setup available at www.spektrumrc.com.

DXe

To use the DXe transmitter with the Blade Inductrix, channel 6 must be reversed.

To reverse channel 6:

1. While powering on the DXe, hold the left and right sticks in the top-inside corners

as shown.

2. Re-center the sticks after the transmitter beeps. The LED will ﬂ ash slowly.

3. To select a channel to reverse, move the right stick to the left or right and allow it

to re-center. Move the stick to the right to select the next channel. Move the stick

to the left to select the previous channel. The LED will ﬂ ash rapidly corresponding

to the channel selected, as shown in the table. Select channel 6.

4. To reverse the selected channel, move the right stick up or down. The LED will

change color to indicate the new channel direction.

The LED will ﬂ ash Orange to indicate the channel is normal.

The LED will ﬂ ash Red to indicate the channel is reversed.

5. To store the changes, power off the DXe.

CAUTION: During the subsequent power up, always verify the throttle

direction is correct and keep clear of the motor and rotor blades. Failure to do

so may result in injury or damage to the product.

After reversing channel 6, bind the transmitter and

quadcopter normally.

Flight modes are controlled by the Flight Mode switch.

Motor Stop is controlled by the Bind/Panic/Trainer button.

™

transmitters with

Inductrix

™

DXe

If you are programming your DXe using the PC or mobile

app, make sure the "Transmitter Channels" value is set to

the default of 7. If for any reason this value is changed

to 9, the Inductrix will bind to the DXe, but will not respond

to control inputs.

If your DXe was included in another Blade Ready To Fly (RTF)

helicopter, the transmitter software will have to be updated

using the appropriate programming cable and either the

PC or mobile app available at www.spektrumrc.com.

Please note, the switch conﬁ guration used for DXe transmit-

ters included with the Blade 230 S RTF and Micro AH-64

Apache RTF varies from the standard DXe layout.

Once bound, the LED in the quadcopter should glow

blue for ﬂ ight mode 0 (Stability, low angle mode), green

for ﬂ ight mode 1 (Stability, high angle mode) and red for

ﬂ ight mode 2 (Agility mode).

If the motors will not start when giving the correct start

command, channel 6 has not been reversed correctly. Use

the directions above to reverse channel 6.

LED Flashes

Channel

1-Throttle

2-Aileron

3-Elevator

4-Rudder

5-Flight Mode

6-Motor Stop

7-Flaps

8-Aux Channel