Cub Cadet CC 3000 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trimmer Cub Cadet CC 3000 herunter. Cub Cadet CC 3000 20 Seiten. C-cycle trimmer

Section 3

Assembly

On some units, the D-handle may be preinstalled and

only require loosening the screws and adjusting the

D-handle to the operator. Go to step 4 for adjusting the

D-handle if preinstalled.

INSTALLING

AND ADJUSTING

THE D-HANDLE

Shaft Grip

(4) Screws_

Shaft

Housing

Minimum 6 inches

(15.24 cm)

D-Handle

Bottom Clamp

(4) Nuts _

Fig. 3-1

Remove the screws, nuts and bottom clamp piece

that were installed on the D-handle for shipping.

Place D-handle the over the shaft housing and onto

the bottom clamp (Fig. 3-1). Place it a minimum of

6 inches (15.24 cm) from the end of the shaft grip.

Hold each hex nut in the bottom clamp recess with

a finger. Start screws with a screwdriver. Do not

tighten until you make the handle adjustment.

If it was preinstalled, loosen the screws on the

D-handle just enough to move the D-handle.

While holding the unit in the operating position

(Fig. 3-2), position the D-handle to the location

that provides you the best grip.

Tighten the clamp screws evenly, until the D-handle

is secure.

Fig. 3-2

,/,z_